![]() You can't add routes to IPv4 addresses that are an exact match or a subset of theįollowing range: 169.254.169.0/22. Matches the traffic (longest prefix match) to determine how to route the If your route table has multiple routes, we use the most specific route that The target must be a NAT gateway, network interface, or Gateway Load Balancer endpoint. The destination must match the entire IPv4 or IPv6 CIDR block of a subnet in your VPC. You can add a route to your route tables that is more specific than the local route. Table at a time, but you can associate multiple subnets with the same subnet route A subnet can only be associated with one route Otherwise, the subnet is implicitlyĪssociated with the main route table. You can explicitlyĪssociate a subnet with a particular route table. Which controls the routing for the subnet (subnet route table). ![]() Each subnet in your VPC must be associated with a route table, Your VPC has an implicit router, and you use route tables to control where network ![]() Table that's associated with an Outposts local gateway. Route tables in Amazon VPC Transit Gateways. For more information, see Transit gateway Table that's associated with a transit gateway. ![]() Network interface of your appliance as the target for VPC traffic. Table with the internet gateway or virtual private gateway, and specify the You use to route inbound VPC traffic to an appliance. That's associated with an internet gateway or virtual private gateway. Options in the Site-to-Site VPN User Guide. For more information about VPN routing options, see Site-to-Site VPN routing This means that you don't need to manually enter VPN routes to your route Virtual private gateway to automatically propagate routes to the route tables. ![]() Or connection through which to send the destination traffic for example, anĪssociation between a route table and a subnet, internet gateway, or virtual For example, an externalĬorporate network with the CIDR 172.16.0.0/12. Where you want traffic to go (destination CIDR). It controls the routing for all subnets thatĪre not explicitly associated with any other route table. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |